I’m sure I’m not the only one using tomato cages, or garden fencing, to protect plants and new sprouts in the garden and yard. Rather they’re protecting from animals, grand kids, or an inattentive mower, they can sometimes stay put most of the summer. That’s what made me think of a large garden cloche; if you’re going to look at it for months, why not make it more attractive? And, no one else will have one like it … that’s always a bonus, right?
My garden cloche design got a jump start when I stumbled upon a pair of wire planter baskets at a local thrift shop for a dollar. The wire spacing on them was similar to a discarded air conditioner guard I had tucked away at home.
I quickly realized I could not bend and shape the steel AC guard to match the 14″dia. of the planter basket with just my hands. After searching around, I finally found an old milk can of that size to roll, wrap, and shape it around. I used bolt cutters to cut the length of guard needed, then connected the ends together by wrapping the entire length of the seam with thin wire, crisscrossing the wire at the intersections, for a smooth seam and firm connection. Cut the wires from bottom ring, leaving prongs to push into the ground.
Cut and remove the crossbars from the bottom of the basket. Once I cut them in the center, they just snapped off.
Spray both of the wire pieces black with an exterior paint recommended for metal. Let dry completely.
I gathered some odd lamp pieces and a short piece of threaded rod to stack and build a large finial to adorn the top of the upturned basket. One lamp piece (the base piece) will need to fit nicely inside the basket below where the crossbars were.
Spray paint the base lamp pieces black, let dry.
Beginning with the painted base pieces on the threaded rod, stack and build the lamp pieces. Leaving room for a small finial, use tape to mark where the threaded rod will need to be cut. Remove the rod to cut, restack the pieces, add a dab of E6000 to the tip of the rod, and twist the small finial on to tighten your pieces together firmly.
Cut back all but 6 or 7 of the wires on the top ring of the AC guard, these will be used to bend over the wire ring of the basket and hold it in place. Touch up the cut wires with black spray paint. Attach the basket to the top and its ready for the garden.
Kind of gives the garden a little majestic touch, don’t you think?